![]() (Refer to the example)Ĥ Make sure the screws are tightly fastened. Soldering should be finished with the proper quantity. When you solder while repairing, please be sure that there are no cold solder and other debris. Please follow the specified safety methods when modification(addition/change of parts) is required due to interferences such as radio/TV interference and foreign noise.ģ Make sure the soldering of repaired locations is properly performed. Be sure to use important parts for safety.Ģ Do not perform modifications without proper instructions. Please conform to product regulations (such as safety and radiation regulations), and maintain a safe servicing environment by following the safety instructions described in this manual. Please be sure to confirm and follow these procedures. In this manual, procedures that must be performed during repairs are marked with the below symbol. A subscription to, or additional copies of, PIONEER Service Manual may be obtained at a nominal charge from PIONEER. For the latest information, always consult the current PIONEER Service Manual. Product Safety is continuously under review and new instructions are issued from time to time. The use of a substitute replacement component which does not have the same safety characteristics as the PIONEER recommended replacement one, shown in the parts list in this Service Manual, may create shock, fire, or other hazards. Replacement parts which have these special safety characteristics are identified in this Service Manual.Įlectrical components having such features are identified by marking with a > on the schematics and on the parts list in this Service Manual. These are often not evident from visual inspection nor the protection afforded by them necessarily can be obtained by using replacement components rated for voltage, wattage, etc. Many electrical and mechanical parts in the appliance have special safety related characteristics. ANY MEASUREMENTS NOT WITHIN THE LIMITS OUTLINED ABOVE ARE INDICATIVE OF A POTENTIAL SHOCK HAZARD AND MUST BE CORRECTED BEFORE RETURNING THE APPLIANCE TO THE CUSTOMER.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |